Not Logged on
[Register] [Logon] 
Section Image Font Size AdjusterDecrease Font SizeIncrease Font Size  

GU tail light removal

Submitted: Sunday, Jun 01, 2003 at 17:14

Michael

Hi all, I need to remove one of my GU tail light to replace the reverse globe, can someone give me a small hint of how this is achieved. I cant see any obvious way to do so. thanks Michael
Advertisement
ThreadID: 5215 Replies: 3
Views: 230 FollowUps: 3
This Thread has been Archived
Thread Summary

AnswerID: 21569   Submitted: Sunday, Jun 01, 2003 at 19:14

outtack replied:

pretty sure the gu model only has the 1 reverse light .
Reply 1 of 3
FollowupID: 14074   Submitted: Sunday, Jun 01, 2003 at 20:12

Michael posted:

Hi there, youre right, its the one thats blown,, Michael
FollowUp 1 of 1
AnswerID: 21571   Submitted: Sunday, Jun 01, 2003 at 19:20

Member - Cocka replied:

Most Gu's only have one reversing light in the LHS. Inside at the rear remove the long thin cover panel. There are a couple of screws/bolts to remove, then easy the whole lamp assembly sideways out of its housing using finger pressure. It may be necesaary to give it a bump with the butt of your hand. good luck.Carpe Diem
Reply 2 of 3
FollowupID: 14073   Submitted: Sunday, Jun 01, 2003 at 20:12

Michael posted:

Thank you, i found the screws,
FollowUp 1 of 1
AnswerID: 21586   Submitted: Sunday, Jun 01, 2003 at 22:58

relaxed (Fraser Coast-QLD) replied:

Michael, just be very careful when you bunp it out. You only have the 2 10mm bolts to remove, but the other side is held in by 2 nipple like plugs which are attached to the plastic of the light assembly, they will break easily if your not careful.
Reply 3 of 3
FollowupID: 14093   Submitted: Monday, Jun 02, 2003 at 10:27

Michael posted:

Thank you, i checked it out with a small torch after removing the bolts so as to see how it was attached, got it out no probs, Thanks again, Regards Michael.
FollowUp 1 of 1